Drawings
Mechanical drawings of the MUXEN enclosures: outside dimensions, mounting holes and the fixing specification, on one A4 sheet each.
For wiring and parameters use the product pages; these sheets are for mounting the box, not for using what is inside it.
Boitier T1
| Drawing | MUX-T1 |
| What it is | Enclosure for the CAN gateways. |
| Overall size | 120 × 75 × 30 mm |
| Material | ABS recyclé noir |
| Mass | 63 g |
| Sheet | A4, scale 1:2 |
| Download | PDF · 59 kB |
Boitier T3
| Drawing | MUX-T3 |
| What it is | Enclosure for the BLOC 8 power-output module. |
| Overall size | 215,5 × 145 × 60 mm |
| Material | ABS recyclé noir |
| Mass | 269 g |
| Sheet | A4, scale 1:2,5 |
| Download | PDF · 81 kB |
BRAIN 2.0
| Drawing | MUX-BRAIN-20 |
| What it is | Enclosure for the BRAIN 2.0 boat computer, with its aluminium heatsink. |
| Overall size | 190 × 200 × 67,5 mm |
| Material | ABS recyclé noir / ALU |
| Mass | 412 g |
| Sheet | A4, scale 1:2,5 |
| Download | PDF · 75 kB |
Mounting
All three enclosures take the same fastener: 4 × Ø4,5 countersunk wood screws, 90° head, DIN 7997, A2 or A4 stainless — two on the Boitier T1, four on the others. Pilot Ø3,0 in plywood, drilled into the face and never into the edge, and aim for at least 15 mm of penetration without going through the panel.
Each sheet carries a 1,2 N·m tightening ceiling. Treat it as an upper limit rather than a target: the enclosures are ABS, and a countersunk head wedges in its seat, so over-tightening cracks an ear. Use a driver with a clutch.